NEC NP1250 - Wireless LAN

19
4. Configuring the LAN Settings of the Projector
Configuring the LAN Settings of the Projector
4
4-2. Wireless LAN
When connecting the wireless LAN, configure the LAN settings in the “WIRELESS” page of
“NETWORK SETTINGS” selected from On-Screen Menu.
Note
n Configuration flowchart
Setting of “CONNECTION”.
Select SSID in “SITE SURVEY”.
Input “SSID” (if necessary).
Select “NETWORK TYPE” (if necessary).
Select “CHANNEL” (if necessary).
Setting of “SECURITY”
Select “SECURITY TYPE”.
Select “KEY SELECT”.
Set “KEY 1 to KEY 4”.
If “EASY CONNECTION” is selected
8
8
9
10
11
12
13
14
15
16
16
1
3
Step Display “WIRELESS” page of “NETWORK SETTINGS”.
4
Step Input “IP ADDRESS”.
2
Step Select “PROFILES”.
5
Step Input “SUBNET MASK”.
6
Step Input “GATEWAY”.
7
Step Input “DNS CONFIGURATION”.
17
Step Confirm the “ADVANCED” settings.
18
Step Reconnect to the network.
19
Step Confirm the settings.
Step - Setting of “ADVANCED”.
Step Enable or disable “DHCP”.
If “Disabled” (without check mark)
If “Enabled” (with check mark)
The wireless LAN cannot be used with VT800.