NEC NP1250 - Wired LAN

28
4. Configuring the LAN Settings of the Projector
4-3. Wired LAN
When connecting a LAN cable to the LAN port of the projector, configure the LAN settings in
the “WIRED” page of “NETWORK SETTINGS” selected from On-Screen Menu.
n Configuration flowchart
1
3
Step Display “WIRED” page of “NETWORK SETTINGS”.
4
Step Input “IP ADDRESS”.
Input “SUBNET MASK”.
Input “GATEWAY”.
2
Step Select “PROFILES”.
5
Step Input “DNS CONFIGURATION”.
6
Step Reconnect to the network.
7
Step Confirm the settings.
Step Enable or disable “DHCP”.
If “Disabled” (without check mark)
If “Enabled” (with check mark)