30
5. Configuring the LAN Settings of the PC ([Example] Wireless LAN in Windows Vista: Ad Hoc connection)
5. Configuring the LAN Settings of the PC
([Example] Wireless LAN in Windows Vista: Ad Hoc connection)
This section explains the procedure for Ad Hoc connection of wireless LAN between the
personal computer and projector, by using the wireless network setting function with Windows
Vista Ultimate.
Preparation:
• If the computer you are using does not have a built-in wireless LAN unit, install a
commercially available wireless LAN card driver to your personal computer, and complete
setup of the wireless LAN card. For details on how to install the driver, refer to the User’s
Manual of the wireless LAN card.
• Check the display of the Windows Vista taskbar. If a network connection utility dedicated
to a wireless LAN unit or a wireless LAN card is running, terminate that utility.
• Configure the wireless LAN settings of the projector. For details, refer to “4. Setting the
LAN Settings of Projector” ( page 15).
This section provides an example for when the projector is configured with the following
wireless LAN settings.
[Example of projector settings]
Item Setting
IP Address 192.168.100.10
Subnet Mask 255.255.255.0
SSID NECPJ
NETWORK TYPE AD HOC
WEP 64bit
KEY SELECT KEY1
KEY 1 NECDS
Click Windows [Start] → [Control Panel].
The “Control Panel” window is displayed.
Click the [View network status and tasks] link that is displayed under
[Network and Internet].
To Next Page
Loading...
