NEC NP1250 - Page 33

33
5. Configuring the LAN Settings of the PC ([Example] Wireless LAN in Windows Vista: Ad Hoc connection)
5
([Example] Wireless LAN in Windows Vista: Ad Hoc connection)
Configuring the LAN Settings of the PC
13
Click [Use the following IP address], and input [IP address] and [Subnet mask].
• For example, if the [IP address] and [Subnet mask] of the projector are set as show in “Example
of projector settings” on page 30, configure the personal computer as shown below.
• Example IP address and subnet mask settings.
Projector ( page 30)
Personal computer (Screen Below)
IP Address 192.168.100.10 192.168.100.30
Subnet Mask 255.255.255.0 255.255.255.0
14
Click [OK].
The “Wireless Network Connection Properties” window is displayed.
15
Click [Close].
The “Wireless Network Connection Status” window is displayed.
16
Click [Close].
The “Network and Sharing Center” window is displayed.
17
Click the [X] in the top-right corner of the window.
The window will close.
This completes the configuration of a wireless LAN Ad Hoc connection on the personal computer
(Windows Vista).
The contents of the PC screen can now be transmitted to the projector using each of the programs
in User Supportware 6.
13 -1
13 -2
14
Click
Click
Click