113
Setting a Password for PJLink [PJLink]
This option allows you to set a password when you use the PJLink feature.
Password: Enter a password (up to 32 characters)
To set and delete a password, repeat steps described in [BACKGROUND LOCK].
NOTE: Do not forget your password. However, if you forget your password, consult with your dealer.
NOTE: What is PJLink?
PJLink is a standardization of protocol used for controlling projectors of different manufacturers. This standard protocol is estab-
lished by Japan Business Machine and Information System Industries Association (JBMIA) in 2005.
The projector supports all the commands of PJLink Class 1.
Setting of PJLink will not be affected even when [RESET] is done from the menu.
Selecting Power-saving in [STANDBY MODE]
The projector has two standby modes: [NORMAL] and [POWER-SAVING].
Power-saving mode is the mode that allows you to put the projector in the power-saving condition which consumes
less power than the Normal mode. The projector is preset for Normal mode at the factory.
NOTE:
• The HTTP server functions are not available during POWER-SAVING mode.
• The MONITOR OUT function is not available during POWER-SAVING mode.
• Control through the PC Control connector and LAN mode is not available during POWER-SAVING mode. For PC control and
LAN mode of the projector it is recommended to leave the projector in the Normal mode.
• When [PROGRAM TIMER] is turned on, the [STANDBY MODE] setting is ignored.
• Your setting will not be affected even when [RESET] is done from the menu.
NORMAL .......................Power indicator: Orange light/Status indicator: Green light
POWER-SAVING ...........Power indicator: Orange light/Status indicator: Off
Turning On or Off Remote Sensor [REMOTE SENSOR]
This option determines which remote sensor on the projector is enabled in wireless mode.
The options are: front/back, front, and back.
6. Using On-Screen Menu
To Next Page
Loading...
