EasyManua.ls Logo

NEC PA803U - Page 120

NEC PA803U
208 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
106
5. Using On-Screen Menu
WARP
Correctprojectedimagedistortiononaspecicsurfaceasacolumnorasphere.
NOTE:
• Whenthemaximumadjustmentrangeisexceeded,distortionadjustmentisdisabled.Setuptheprojectoratanoptimalangle
since the more the adjustment volume gets large, the more image quality gets deterioration.
• Pleasenotethattheimagewillgooutoffocusduetothedifferenceinthedistancebetweenperipheriesandthecenterofthescreen
forprojectionscuttingacrosscornersasonacolumnorasphere.Lenseswithshortfocalpointsarealsonotrecommendedfor
projections cutting across corners as the image will go out of focus.
Adjustment method
1. Alignthecursorwiththe[WARP]ofthe[GEOMETRICCORRECTION]menuandthepresstheENTER.
• Adjustmentscreenwillbedisplayedon.
2. Press the ▼▲◀▶buttonstoalignthecursor(bluebox)withthetargetadjustmentpointandthenpressthe
ENTER.
• Thecursorwillchangeintoanadjustmentpoint(yellowincolor).
3. Press the ▼▲◀▶buttonstoadjustthecornersorsidesofthescreenandthenpresstheENTER.
• Thecursorwillbacktoyellowbox.
Explanation for correcting distortion
• Eightadjustmentpointscanbemovedindependently.
• Forleftandrightsides,use/ buttons for adjusting the range of distortion, and / buttons for adjusting
the distortion peak.
• Fortopandbottomsides,use/ buttons for adjusting the range of distortion, and / buttons for adjusting
the distortion peak.
• Forcorners,use▼▲◀▶ buttons for moving positions.
a
b
c
e
h
d
g
f
b
a
c
d
e
f
g
h
4. Foradjustingotherpoints,repeatStep2onwards.
5. Whentheadjustmentiscompleted,movethecursorontothe[EXIT]ontheadjustmentscreenandpress
theENTER.
• Thescreenwillbeswitchedtothe[GEOMETRICCORRECTION]menu.
The adjustment completion screen will be displayed on.
6. Press or buttontomovethecursoronto[OK]thenpress[ENTER].
• TheadjustedvaluesforWARParestoredandthescreendisplaygoesbacktothe[GEOMETRICCORREC-
TION].
TIP:
AcommerciallyavailableUSBmouseisavailabletoperformcorrection.( page 40)

Table of Contents

Related product manuals