NEC PA803U - ❽ Turning Off The Projector

31
2. Projecting an Image (Basic Operation)
❽ Turning off the Projector
To turn off the projector:
1. First, press the  (POWER) button onthe projector
cabinetortheSTANDBYbuttonontheremotecontrol.
The [POWER OFF / ARE YOU SURE ? / CARBON SAV-
INGS- SESSION 0.000[g-CO2]] message will appear.
2. Secondly, press the ENTER button or press the
(POWER)ortheSTANDBYbuttonagain.
The lamp will go off and the power supply will be cut. If
no operation is performed on the projector and no signal
is input to the projector, the projector will be in standby
state. The POWER indicator will light in orange (In the state,
the standby mode is NORMAL and the PROFILE for the
WIRED LAN is available.).
Power On
Steadily lights in
blue
Sleep
Blinks in orange
CAUTION:
PartsoftheprojectormaybecometemporarilyheatediftheprojectoristurnedoffwiththePOWERbuttonorifthe
ACpowersupplyisdisconnectedduringnormalprojectoroperation.
Usecautionwhenpickinguptheprojector.
NOTE:
• WhilethePOWERindicatorisblinkingblueinshortcycles,thepowercannotbeturnedoff.
• Youcannotturnoffthepowerfor60secondsimmediatelyafterturningitonanddisplayinganimage.
• Donotunplugthepowercordfromtheprojectororfromthepoweroutletwhileanimageisbeingprojected.Doingsocould
deterioratetheprojector’sACINterminalorthepowerplug’scontact.ToturnofftheACpowerwhileanimageisbeingprojected,
usethepowerstrip’sswitch,thebreaker,etc.
• DonotdisconnecttheACpowersupplytotheprojectorwithin10secondsofmakingadjustmentorsettingchangesandclosing
themenu.Doingsocancauselossofadjustmentsandsettings.