NEC PA803U - 3. Convenient Features; Projector Security Function

29
2. Projecting an Image (Basic Operation)
Adjusting the Tilt Foot
1.Turntheleftandrighttiltfoottoadjust.
The tilt foot lengthen and shorten when turned.
Turn one of the tilt foot to adjust the image so that it is level.
• Iftheprojectedimageisdistorted,see“3-6CorrectingHorizontal
and Vertical Keystone Distortion [CORNERSTONE]” (→ page 38)
and “[GEOMETRIC CORRECTION]” (→ page 103).
• Thetiltfootcanbelengthenedbyamaximumof20mm.
• Thetiltfootcanbeusedtotilttheprojectorbyamaximumof4°.
NOTE:
• Donotlengthenthetiltfootanymorethan20mm/0.8".Doingsowillmakethe
tiltfoot’smountsectionunstableandcouldcausethetiltfoottocomeoffthe
projector.
• Donotusethetiltfootforanypurposeotherthanadjustinginclinationofthe
projector installation angle.
 Handlingthetiltfootimproperly,suchascarryingtheprojectorbygraspingthe
tilt foot or hooking it onto a wall using the tilt foot, could damage the projector.
Up
Tilt foot
Down