NEC PA803U - Terminals

10
1. Introduction
Terminals
2 73 1
4
5
811
12
13 10
6
9
1. HDMI1INTerminal(TypeA)
(→page144,145,147)
2. HDMI2INTerminal(TypeA)
(→page144,145,147)
3. DisplayPort IN Terminal
(→page144)
4. COMPUTERIN/ComponentInputTerminal(Mini
D-Sub15Pin)
(→page143,146)
5. COMPUTERAUDIOINMiniJack(StereoMini)
(→page143,145)
6. HDBaseTIN/EthernetPort(RJ-45)
(→page148,149)
7. HDBaseT OUT/EthernetPort(RJ-45)
(→page63,149)
8. AUDIOOUTMiniJack(StereoMini)
(→page143,145,147)
9. USB-APort(TypeA)
(→page122)
10. LANPort(RJ-45)
(→page152)
11. 3DSYNCTerminal(MiniDIN3Pin)
(→page46)
12.PCCONTROLPort(D-Sub9Pin)
(→page178)
 Use this port to connect a PC or control system.
Thisenablesyoutocontroltheprojectorusingserial
communicationprotocol.Ifyouarewritingyourown
program,typicalPCcontrolcodesareonpage188.
13.REMOTETerminal(StereoMini)
Use this terminal for wired remote control of the
projectorusingtheNECremotecontrolforPX750U/
PH1000U/PH1400Useries.
 Connectthe projector and our remote control,RD-
465E,usinga commercially availablewiredremote
control cable.
NOTE:
• WhenaremotecontrolcableisconnectedtotheREMOTE
terminal, infrared remote control operations cannot be per-
formed.
• When [HDBaseT]is selected in the[REMOTE SENSOR]
and the projector is connected to a commercially-available
transmissiondevicethatsupportsHDBaseT,remotecontrol
operations in infra-red cannot be carried out if transmission
of remote control signals has been set up in the transmission
device.However,remotecontrolusinginfraredrayscanbe
carried out when the power supply of the transmission device
is switched off.