NEC PE523X - ❸ Turning On The Projector

12
2. Projecting an Image (Basic Operation)
❸ Turning on the Projector
1. Remove the lens cap.
With the lens cap’s stopper pressed up, pull forward and
off.
Stopper
2. Press the (POWER) button on the projector cabinet
or the POWER ON button on the remote control.
The POWER indicator will blink and the projector will
become ready to use.
TIP:
• Whenthe message“Projectoris locked! Enter your password.”
isdisplayed,it means that the[SECURITY] feature is turned on.
(→page33)
After you turn on your projector, ensure that the computer
or video source is turned on.
NOTE:Whennoinputsignalispresent,theno-signalguidanceisdisplayed
(factorymenusetting).
Standby Blinking Power On
Blinking orange light Blinking blue
light
Steady blue
light
(→page113)