NEC PE523X - Setting Up The Projector For A Wired Lan Connection [Wired Lan]

77
5. Using On-Screen Menu
Setting up the Projector for a Wired LAN Connection [WIRED LAN]
Important
• Consultwithyournetworkadministratoraboutthesesettings.
• WhenusingawiredLANconnection,connect a LAN cable (Ethernet cable) to theLANport(RJ-45)ofthe
projector.(→page99)
TIP:Thenetworksettingsyoumakewillnotbeaffectedevenwhen[RESET]isdonefromthemenu.
[WIREDLAN] [DISABLE] WiredLANconnectionwillbeturnedoff.
[ENABLE] WiredLANconnectionwillbeturnedon.
[SETTINGS] [DHCP] ON ��������������������������� IP address, subnet mask, and gateway will be
automatically assigned to the projector from
your DHCP server�
OFF�������������������������� Specify IP address, subnet mask, and gateway
assigned by your network administrator�
[IPADDRESS] Set your IP address of the network connected to the
projector.
[SUBNETMASK] Setyoursubnetmasknumberofthenetworkconnected
to the projector.
[GATEWAY] Setthedefaultgatewayofthenetworkconnectedtothe
projector.
[AUTODNS] ON ��������������������������� DHCP server will automatically assign IP address
of DNS server connected to the projector�
OFF�������������������������� Set your IP address of DNS server connected
to the projector�
[RECONNECT] Retrytoconnecttheprojectortoanetwork.