NEC PE523X - Page 81

70
5. Using On-Screen Menu
Selecting Communication Speed [COMMUNICATION SPEED]
This feature sets the baud rate of the PC Control port (D-Sub 9P). It supports data rates from 4800 to 38400 bps.
The default is 38400 bps. Select the appropriate baud rate for your equipment to be connected (depending on the
equipment, a lower baud rate may be recommended for long cable runs).
NOTE: Your selected communication speed will not be affected even when [RESET] is done from the menu.
Selecting the serial port [SERIAL PORT] (not supported by P603X/PE523X)
This sets which terminal on the projector will receive the serial control signals for remotely controlling the projector
from a commercially available HDBaseT transmission devices (control signals for turning the power on and off, etc.).
There is no need to make this setting if not operating the projector by remote control (only sending video and audio).
PC CONTROL �������������������������Control signals (RS232C serial communications) are received at the PC CONTROL terminal�
HDBaseT ������������������������������� The video/audio and control signals (RS232C serial communications) are received at the HDBaseT port�
NOTE:
• When[HDBaseT]isset,itwillnotworkwhentheprojectorisinthestandbymode,regardlessofwhether[STANDBYMODE](→page74)
issetto[NORMAL]or[NETWORKSTANDBY](thepowercannotbeturnedon).
 Themethodsbelowcanbeusedtoturnontheprojector’spowerwhenitisinthestandbymode.
• Theprojectorcanbeoperatedbyconnectingthecomputerandprojectoroverthenetwork(ontheprojector,usingtheLANport,with
[STANDBYMODE]setto[NETWORKSTANDBY])
TIP:
• WhencontrollingtheprojectorusingtheLANport,thisworkswitheithersetting.
Turning On or Off Remote Sensor [REMOTE SENSOR]
Set the remote control sensors on the projector’s front and rear panels and the HDBaseT remote control sensor.
The options are: ALL, FRONT/BACK, FRONT, BACK, and HDBaseT.
(HDBaseT is not supported by P603X/PE523X)
NOTE:
• When[HDBaseT]isset,itwillnotworkwhentheprojectorisinthestandbymode,regardlessofwhether[STANDBYMODE](→page74)
issetto[NORMAL]or[NETWORKSTANDBY](thepowercannotbeturnedon).
TIP:
• Iftheremotecontrolsystemdoesnotfunctionwhendirectsunlightorstrongilluminationstrikestheremotecontrolsensoroftheprojector,
changeanotheroption.
• Theremotecontrolsensoronthebackoftheprojectorcannotbeusedwhentheseparatelysoldcablecoverismountedontheprojector.