To Next PageTo Next PageWhat to do if POWER/STANDBY indicator is blinking in red on NEC PlasmaSync 42VP4 (42Wide VGA)?
If the POWER/STANDBY indicator is blinking red on your NEC monitor, immediately switch off the power and wait for the internal temperature to decrease, as this indicates the protector has been activated due to high internal temperature.
What to do if NEC PlasmaSync 42VP4 (42Wide VGA) Monitor picture appears but no sound is produced?
If you see a picture but hear no sound from your NEC monitor, first increase the volume. Then, check if mute mode is enabled by pressing the remote control’s MUTE button. Also, ensure the speakers are properly connected and the AUDIO INPUT is correctly set in the AUDIO menu.
What to do if POWER/STANDBY indicator is lighted in red on NEC Monitor?
If the POWER/STANDBY indicator on your NEC monitor is red, check the input signal to ensure the horizontal and/or vertical sync signal is present when the Intelligent Power Manager control is on.
Why the remote control of NEC PlasmaSync 42VP4 (42Wide VGA) does not work?
If the NEC monitor's remote control isn't working, replace both batteries with new ones. Check if IR REMOTE is set to ON and, if so, set it to OFF in the OPTION3 menu. If an ID number has been set for the main unit, either set an ID number with the ID SELECT button or set the ID number to ALL.
Why NEC PlasmaSync 42VP4 (42Wide VGA) does not operate when the remote control’s buttons are pressed?
If your NEC monitor isn't responding to the remote, make sure the remote is pointed at the monitor's sensor without any obstructions. Also, check if direct sunlight or strong artificial light is interfering with the sensor; if so, eliminate the light. Replace the remote batteries if they are worn out. Finally, ensure the remote cable is unplugged from the REMOTE IN terminal.
How to adjust if image is too large or too small on NEC Monitor?
If the image on your NEC monitor is too large or too small, press the WIDE button on the remote control and adjust properly.
How to adjust if part of picture is cut off or picture is not centered on NEC Monitor?
If part of the picture is cut off or the picture is not centered on your NEC monitor, adjust the IMAGE ADJUST properly.
General