NEC SV9100 Setup Guide

Issue 1.0
SV9100 Dialer Setup Guide (Multiline Telephone) 1-3
2.1.3 Using DHCP
To use Dynamic IP Addressing via DHCP, refer to the following procedure:
1. Press the Settings icon on APPS.
2. Choose Ethernet Settings.
3. Select Ethernet configuration.
4. Select DHCP on Connection Type and click Save.
2.1.4 Using Static IP
The following procedure is to change the IP Address of the UT880 or
change the obtaining IP address method from DHCP to Static IP in
accordance to the network environment.
1. Press the Settings icon on APPS.
2. Choose Ethernet Settings.
3. Select Ethernet configuration.
4. Select Static IP on Connection Type menu.
5. Enter IP Address, Netmask, DNS, Default Router and press Save.
SECTION 3 SPECIFICATIONS
The following are specifications of the UT880.
Main Item Sub Item Specification
System
CPU ARM Cortex-A9 Dual MicroProcessor with 512KB L2 Cache
Flash Memory 4GB NAND Flash
SDRAM 1 GB DDR2 SDRAM
CODEC G.711u/a, G.729, G.722, H.264
Voice Interface
Handset Supported
Headset Supported
Speaker Phone Supported
Network
LAN 10/100/1000Base-T with Auto MDIX
PC 10/100/1000Base-T with Auto MDIX
Bluetooth BT V2.1+EDR

NEC SV9100 Specifications

General

Unified Messaging	Yes
VoIP Support	Yes
SIP Support	Yes
VoIP Protocols	SIP, H.323
Mobility	Yes
Type	IP-PBX
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	0°C to 40°C (32°F to 104°F)
Humidity	10% to 90% (non-condensing)
System Type	Hybrid (Supports Analog, Digital, and IP)