SV9100 Dialer Setup Guide (Multiline Telephone) 2-1
Chapter 2
UNIVERGE
®
SV9100
UT880 NMLT Multiline Telephone
Application
SECTION 1 CONFIGURING MULTILINE TELEPHONE APPLICATION ACCOUNT
I
NFORMATION ON THE UT880
These instructions assume that the proper licensing has been applied to the SV9100
to support multiline stations.
The following licenses and components are required to support each UT880 Multiline
phone:
GCD-CP10 with GPZ-IPLE Daughter Board installed
System Version R1 License (0411)
System Port License (0300)
VoIP Resource License (5103)
IP Terminal License (5111)
The settings below are needed, with the exception of optional authentication, on the
SV9100 to support Multiline stations. If the SV9100 has already been configured to
support Multiline stations, then skip to Section 2 Multiline Telephone Application
Automatic Configuration on page 2-5.
Set 10-12-01 to 0.0.0.0.
Set 10-12-03 to the default gateway provided by the network administrator.
Set 10-12-04 to the local time zone.
To Next Page
Loading...
