NEC UNIVERGE DT310 - Connecting Line Cord

22
CONNECTING LINE CORD
STEP 1: Insert Line cord plug into Line connector on
the back of the telephone set until you hear it
clicks.
STEP 2: Thread the line cord through the groove on
the back of the telephone.
STEP 3: Lead the line cord out through the groove on
the tilt leg as shown in the figure below.
DT330/DT310
Line Cord
Line Cord Plug
Line Connecto
r
Telephone
Line Code
Groove
Telpehone
Tilt Leg
Groove
Line Cord