NEC UNIVERGE DT310 - To Originate a Call Using Speed Calling (-Station;Group); To Originate a Call Using Speed Calling - System

44
To Register Speed Calling Number On 8LD
Display
Follow the procedure of To program in To Origi-
nate a Call Using Speed Calling (One-Touch
Speed Calling Keys).
TO ORIGINATE A CALL USING
SPEED CALLING (-STATION/
GROUP)
Press key.
Press the desired speed calling number.
TO ORIGINATE A CALL USING
SPEED CALLING - SYSTEM
To Program Speed Calling – System Key
(On One-Touch Speed Calling Key)
Press key.
Press desired One-Touch Speed Calling key. The
LCD displays previously stored digits.
Dial the “Speed Calling – System” access code and
the abbreviated call code.
Press key again.
To Operate From Speed Calling – System
Key
Press the “Speed Calling – System” key.
If the DT Series does not have the “Speed Calling –
System” key, dial the “Speed Calling – System”
access code, then the abbreviated call code.
To Operate From Directory Key
(Only DT310 Series are equipped with Directory key.)
Press key.
Dial the abbreviated call code (maximum of 4 dig-
its).
DT330/310
Redial
XXXXXX
LNR[ ]/SPD[_ _] ‚Ä
*
DT330/310
Feature
Feature
4:26 PM TUE 13 APR 2004
SPEED SET
4:26 PM TUE 13 APR 2004
XXXX
Directory
4:26 PM TUE 13 APR 2004
XXXX