– 84 –
CHAPTER 4 OFFICE DATA DESIGN
3. After the announcement starts to be played, Multiple Connection function is provided for six seconds
(fixed). Thus, no tone or music is recorded in the part of and the message is recorded in the part
of .
4. Prepare the required number of circuits so that all incoming calls can be connected with the DAT using with
Multiple connection function.
Multiple connection
Single connection
64 sec.
(Announcement is completed)
(Announcement is completed)
(Announcement is completed)
128 sec.
240 sec.
064
6 128 240 (sec.)
Incoming Calls
Recording time
Ex. 16sec. mode (max. 4CHs/card)
Circuit 0
Circuit 1
Circuit 2
Circuit 3
016
18 226 12 24 28 34 40 (sec.)
Time
: IC calls
Note: In this case, the DAT that has more than 3 circuits should be used.
To Next Page
Loading...
