4
1. Introduction
Adjustable Tilt Foot
(
→
page 21)
Rear Foot (Left / Right)
(
→
page 21)
Adjustable Tilt Foot Button
(
→
page 21)
Lamp Cover
(
→
page 50)
Carrying handle
Screw
Phillips-head screwdriver
(not supplied)
Attaching the supplied carrying handle
You can carry the projector by attaching the supplied carrying handle securely to the projector.
To attach the supplied carrying handle, use a Phillips-head screwdriver and the supplied two screws.
Place a soft cloth on the working surface before turning the projector over to prevent scratching the top cover.
Make sure that the carrying handle is attached with correct orientation as shown below.
CAUTION
When carrying the projector by the carrying handle, make sure the two screws that attach the carrying handle
to the projector cabinet are tight.
Bottom
To Next Page
Loading...
