NEC VT700 - After Use

27
 After Use
Preparation: Make sure that the projector is turned off.
1. Unplug the power cable.
2. Disconnect any other cables.
3. Retract adjustable tilt foot if extended.
4. Cover the lens with the lens cap.
5. Put the projector and accessories in the supplied soft case.
Place the projector in the soft case with the lens facing upward as shown below. This is to prevent the lens from
damage.
3. Projecting an Image (Basic Operation)
NOTE: When placing the projector in the soft case, retract the tilt foot and the rear feet. Failure to do so may case damage to the
projector.
CAUTION:
Use caution when putting the projector in the soft case immediately after the projector has been operating. The
projector cabinet is hot.
M
E
N
U
S
E
L
E
C
T
L
A
M
P
S
T
A
T
U
S
P
O
W
E
R
ON/STAND BY
S
O
U
R
C
E
AUTO ADJ.
E
N
TE
R
E
X
IT
FOCUS
ZOOM
MENU
SELECT
LAMP
STATUS
POWER
ON/STAND BY
SOURCE
AUTO ADJ.
EN
TER
E
X
IT
Insert the projector with the lens
facing upward