NEC Xen Topaz - For Your Convenience; Programming a Function Key; Programming a DSS;One-Touch Key

For Your Convenience
 There are 2 levels of Function Keys. (General Keys : assigned by 851, Appearance Keys : assigned by
852)
 Appearance Keys have priority. You can overwrite the Appearance Key at the General Key.
 If you want to overwrite the General Key at the Appearance Key,
you have to erase the Appearance Key
by dialling “852 + 000” before General Key assignment.
 In the default setting, Programmable Function Key No. 1 to 12 is assigned as “Trunk” Key. If you want to
assign Function Keys (General) at the unused Trunk Keys, these unused keys should be erased by “852 +
000” operation.
 Pro
g
rammable Function Ke
y
s can be erased b
y
diallin
g
“
852 + 00
0
”
or
“
851 + 0
0
”
.
Program Function Keys
Programmable Function Keys can be assigned as “Trunk” Key and/or other Function Keys. You can just press
the function key to activate the assigned function without dialling the Service Code.
?
SPK
?
Code + Additional Data
?
CALL Function Ke
y
8 5 1
8 5 2
Program DSS/One-Touch Keys
??
 In the default setting, Programmable Function Key No. 1 to 12 is assigned as “Trunk” Key. If you want to
assign DSS Keys at the unused Trunk Keys, these unused keys should be erased by “852 + 000”
operation before the above operation.
 In case of DSS Key, the extension status can be indicated on the BLF. (idle : extinguished, Busy : lit)
 When you register a telephone number, “9” (Trunk Access Code) should be added on top of number.
 Up to 24 digits dialling can be registered, but the name can not be registered.
 If
y
ou want to continue the o
p
eration
,
p
ress Pro
g
rammable Function Ke
y
instead of SPK Ke
y
to finish.
Programmable Function Keys can be assigned as DSS (Direct Station Selection) or One-Touch Keys. You can
place an Outside / Intercom Call just pressing this key without dialling the number.
CALL
8
Function Ke
y
5 1 10
Tele
p
hone Numbe
r
SPKHOLD
??
0
?
Extension Numbe
r
2