Install the Batteries
XN120 Battery Box Guide 7
3- Install the batteries
! CAUTION - do not short-circuit the battery terminals.
1 Fit the two batteries into the
battery box.
Refer to the Connection Diagram earlier in this guide.
Ensure the battery terminals are towards the front.
2 Secure the batteries using the
retaining bracket.
Locate the two fixing brackets supplied with the bracket into the key
slots on the inside of the back panel of the battery box.
Fit the retaining bracket across the front of the batteries.
Secure the retaining bracket with the two wing nuts.
3 Connect the batteries together. Using one of the orange cables connect the +’ve terminal of one of the
batteries to the –‘ve terminal of the OTHER battery.
CAUTION - DO NOT SHORT-CIRCUIT the battery terminals.
4 Connect the batteries to the
socket within the battery box.
The plug on the red/blue cable
is polarity sensitive; ensure
you connect correctly.
Using the red/blue cable with two terminals connect the remaining +’ve
and –‘ve battery terminals to the 2-pin socket inside the battery box.
CAUTION – Ensure you:
Connect the red cable to the
+ battery terminal.
Connect the blue cable to the
– battery terminal.
There are plastic retaining clips on the inside of the back panel of the
battery box to secure the red/blue cables.
5 Replace the front cover of the
battery box.
Write the date of installation on
the label on the front cover of
the battery box.
+ -
+ -
+ -
+ -
RED
BLUE
To Next Page
Loading...
