Connect the Battery Box to the XN120
8 XN120 Battery Box Guide
4- Connect the Battery Box to the XN120
! You must power off the system before the battery box is connected to the XN120 unit.
1 Power off the XN120 system. You must also power off any expansion units if they are installed.
2 Remove the sub cover of the
XN120 Unit.
2 Connect the cable from the
battery box to the socket in the
XN120 unit.
The plug on the battery box
connecting cable is polarity
sensitive; ensure you connect
correctly.
! If you have any XN120
Expansion units you must
connect a separate battery box
to each XN120 expansion unit.
Ensure the connecting cable from the battery box can not become
damaged; tie up any loose cable.
3 Re-fit the XN120 sub cover.
Push
Slide
To Next Page
Loading...
