Power On the System
XN120 Battery Box Guide 9
5- Connect the Power & System Start Up
1 Ensure the NORMAL switch is
set correctly.
! System Start Up – Retain Customer Configuration
This is the normal operation for powering the XN120 on.
Before you power on the system check that the NORMAL switch is set
to ON. This will ensure that the system memory retains your
configuration.
The NORMAL switch is located to the right of the MOH/Page
connector on the main unit, refer to the Getting Started Guide supplied
with the XN120 for further information.
2 Power on the XN120. If you have any XN120 expansion units power these on first.
Switch on the power with the switch at the left side of the XN120 unit.
To Next Page
Loading...
