NEC XN120 - 4- Connecting the Expansion Units to the EXIFU card

Configure IP Addresses
XN120 Voice Over IP Card Guide 11
You must power the XN120
system off/on for the new IP
address to take effect.
Ø Press HOLD to confirm the entry.
Ø Press DC several times when you are done to return to the
Program Mode.
Ø (Press SPK to save changes and exit if you are finished).
Configuration Sheet : IP Addresses
Program 10-12-01
IP Address =
Program 10-12-02
Subnet mask =
Program 10-12-03
Default Gateway =
Program 84-05-01
VOIPU IP (Slot 5) =
VOIPU IP (Slot 6) =
VOIPU IP (Slot 11) =
VOIPU IP (Slot 12) =
VOIPU IP (Slot 17) =
VOIPU IP (Slot 18) =