NEC XN120 - 7- Connect the VOIPU Circuits to the Data Network; Ethernet Port Specification; Ethernet Cable; Maximum Cable Length

Connect the VOIPU Circuits to the Data Network
8 XN120 Voice Over IP Card Guide
7- Connect the VOIPU Circuits to the Data Network
1 Connect each VOIPU circuit to
the data network.
At this point you should also
connect the EXIFU-A1
Ethernet port to the data
network.
Ethernet Port Specification
Standard IEEE802.3 10Base-T and 100Base-TX compliant
Access CSMA/CD
Speed 10Mbps/100Mbps Auto Negotiation Interface
Cable CAT5 or better Straight/Cross
Ethernet Cable
The connections of the Ethernet cable depend on the device that you
connect. When connecting to an Ethernet hub you would normally use
a straight cable (some hubs will take either a straight or cross cable)
When connecting directly to the NIC card in your PC you must use a
cross cable.
RJ45 Ethernet
socket on the
VOIPU
RJ45 colour
code
Ethernet
Straight Cable
Ethernet
Cross Cable
1 White/Orange 1 3
2 Orange/White 2 6
3 White/Green 3 1
6 Green/White 6 2
Maximum Cable Length
The maximum cable length is 100 metres for straight and cross cables.
Ethernet port