NEC XN120 - 8- Ports Assigned

Configure Incoming Calls
20 XN120 Voice Over IP Card Guide
Set the VOIPU lines as DDI Mode.
At default all lines are set as Normal (i.e. Non-DDI).
Program 22-02-01
You will need to change this
setting for each VOIPU line.
! Ensure that you set the lines
to DDI for all of the 8 night
modes.
! Ensure that you change the
correct VOIPU trunks to DDI,
do not change an analogue
trunk to DDI type as this will
stop it working correctly.
Ø Select the correct trunk number with the Vol.
p q keys.
You will see the setting for night mode 1.
Ø Change the type to 3 to set the line as DDI.
Ø Press HOLD to confirm the entry and step to the next night
mode.
Ø When you have changed all 8 night modes to type 3 the next
trunk number will be displayed.
Ø Change this trunk to DDI type if required
Or
Ø Press DC several times when you are done to return to the
Program Mode.
(Press SPK to save changes and exit if you are finished).
Assign each VOIPU line to a Trunk Group.
At default all lines are in Trunk Group number 1. All VOIPU trunks should be assigned to the same Trunk
Group number
Program 14-05-01
There are 25 trunk groups
available
! Ensure that you set the lines
to DDI for all of the 8 night
modes.
! Ensure that you change the
correct VOIPU trunks to DDI,
do not change an analogue
trunk to DDI type as this will
stop it working correctly.
Ø Select the correct trunk number with the Vol.
p q keys.
Ø Enter the Trunk Group Number.
Ø Press HOLD to confirm the entry.
Ø Enter the Priority. This determines which trunks should be
used first from the selected Trunk Group.
Ø Press HOLD to confirm the entry and step to the next Trunk.
Ø Press DC several times when you are done to return to the
Program Mode.
(Press SPK to save changes and exit if you are finished).
22-02-01 Trunk 04
Mode1 TRK T
yp
e=3
Press Vol p q
to select the
trunk number
14-05-01 Trunk 1
Grou
p
No. 1
Press Vol p q
to select the
trunk number
14-05-01 Trunk 1
Priorit
y
1
Press Vol p q
to select the
trunk number