What’s Included?
6 XN120 Voice Over IP Card Guide
1- Unpack the Card.
The VOIPU card is not supplied with any connection cables.
Additional Items Required:
Cross head screwdriver.
RJ45 patch cable for each VOIPU. (straight through connections).
Optional Items
You must have a spare slot available in a 2OPBOX to install each VOIPU card.
2- Install Daughterboard (if required).
! Observe anti-static precautions when handling the VOIPU cards.
· Wear a suitable anti-static strap connected to an Earth point.
· Place the VOIPU on a flat surface, with the PCB facing upwards.
· Remove the daughterboard from its packaging and locate the black 40-pin connector on the PCB (CN11
on the VOIPU and CN6 on the Daughterboard).
· Gently place the daughterboard onto the VOIPU so that the 4 plastic legs locate into the holes on the
VOIPU and the 40-pin connectors meet up.
· Apply firm, even pressure to the four plastic areas on the daughterboard until the legs click into place on
the VoIPU.
3- Power Off the System.
You must power off the XN120 system before you install the VOIPU card into a slot in the 2OPBOX.
4- Fit the EXIFU-A1.
Refer to the installation instructions supplied with the EXIFU-A1.
5- Fit the 2OPBOX.
Refer to the installation instructions supplied with the 2OPBOX.
The VOIPU card is installed into a free slot in a 2OPBOX, ensure you fit the 2OPBOX before you install the
VOIPU card.
To Next Page
Loading...
