Installation and Configuration | AEOS Blue and vehicle identification EN
Manual version 3 19/48
Update the uPASS reader firmware (if necessary)
The cards are encoded with a specific Nedap customer code. You must use the same customer
code for the uPASS reader. Specific firmware is required, depending on the type of interface you
use to connect the reader to the AEOS Blue controller.
By default, the TRANSIT reader is configured with the correct end user customer code. If the
settings need to be changed, you must upload the P81 firmware with the correct customer code to
the reader. For this, you need a dedicated Nedap Firmware Upgrade software tool. Nedap
Identification Systems can provide you with the correct firmware and tools.
The example below shows a firmware upload with (in this case, for example) customer
code DF1814.
Uploading P81 firmware with the Nedap Firmware Upgrade software tool
1. Log in to the Nedap Identification Systems partner portal
2. Download and install the
PICLoader software.
3. Connect the Transit reader to the computer.
4. Open the
PICLoader software tool.
5. Click the 'open folder' icon and select the correct uPASS firmware.
6. Click
Download.
7. Close the
PICLoader software tool.
To Next Page
Loading...