Installation and Configuration | AEOS Blue and vehicle identification EN
Manual version 3 27/48
4.3 Configuring AEmon
To configure the AEOS Blue controller for the ANPR Access reader in AEmon, take the following
steps:
Configure the identifier type in AEmon
1. Start AEmon
2. In AEmon, create/open the configuration, including the AP7803 AEOS Blue controller, the
IPBadge AEbc and the StandardDoor access point (see the AEOS Access Points and
Entrances manual).
3. Right-click the
StandardDoor AEbc, and click Properties.
4. Open the Identifier type editor and select Generic.
To Next Page
Loading...