Nedap AP7803 - Configure the Anpr a

Installation and Configuration | AEOS Blue and vehicle identification EN
Manual version 3 26/48
Configure the ANPR Access reader
1. Enter the reader's IPaddress (or NetBiosName) in the address bar of your web browser
and log in.
2. Go to
Plate reader >Event actions.
3. Enable the
TCP Message on OCR read option.
4. Check the settings. See the example below. The Server IP address that you must enter
here is the IP address of the AEOS Blue controller (see the AEOS hardware configuration
manual). The
Server port number must match the server port number set in AEmon (see
section 4.3).
5. Click Apply.
Step
01