VP1007-B / Installation manual
Version 01.000 / November 2020 / EN
13
Livestock Management
5 Commissioning
Caution
Before commissioning and handing over the system to the user, the installer must perform several checks
and tests to verify that the system functions flawlessly. Encountered issues and problems must be solved
first.
5.1 Testing inputs and outputs
The inputs and outputs of the VP1007-B can be tested with three tests:
1. Input/output test for Nedap feed motors.
2. Output test to check connected equipment like lights, valves or relays.
3. Input test to check connected equipment like switches and sensors.
The tests are performed using the menu options described in VP1007-B reader menu overview (page 26)
Feed motor test
The feed motor test is a combination of an input and output test.
1. Go to It > o1 to test the feed motor on the connector I/O 1.
When the test is finished, the test results are shown as a code on the display (blinking).
Code on the
display
Description motor test results
00 Motor run ok
01 Output already in use
02 No motor current measured
03 No input signal seen
06 Motor current too high for too long
08 Current still measured after test has stopped
09 Output voltage is stopped due to motor safeguard function
10 Output already in use
12 Motor current too low while running
13 Previous motor command finished, output still active
a. When the test result is not OK (higher than 00): Fix the problem and go to It > dE to reset the error.
2. If applicable, repeat step 1 for option o2, o3, o4 or o5 to test feed motors on connector I/O 2, I/O 3, I/O 4 or
I/O 5.
Output test
The output test is used to test connected equipment like light, valves or relay on the output connectors.
1. Go to It > L1 to test the connected equipment on output 1.
The output is switched on.
2. Check if the green LED of the output is on.
A red blinking LED indicates an output error.
3. Go to It > dE to reset the output errors.
4. Check if the connected equipment is activated.
To Next Page
Loading...
