Nedap VP1007-B - Appendix and References; VP1007-B LED Indicator Guide

VP1007-B / Installation manual
Version 01.000 / November 2020 / EN
25
Livestock Management
11 Appendix
11.1 VP1007-B reader LED indicators
LED Color  Mode State
Green On Power on
POWER
Blank Off Power off
Slow blinking Working and linked to Behavior Component
1 long flash Working and not linked to Behavior Component
Fast blinking Downloading or error during download
1 short flash V-pack not coupled
2 short
flashes
Firmware present but not active
STATUS Blue
3 short
flashes
No firmware present
On 
Address
indicated
No communication
Display
Off   Communication status OK
Green On Power on
Blank Off No power
On Low power warning, lower than 20VOrange
Blinking Wrong CAN bus connection, Vi and Vo swapped
Vi
Red On Error (Overload or Vi and Vo swapped)
Green On Power on
Blank Off No power
Orange Blinking Low power warning
Vo
Red Blinking Error (Overload or Vi and Vo swapped)
Green On V-pack is last one on the CAN bus
Blank Off V-pack is not last one on the CAN bus
Orange Blinking CAN bus error and last V-pack on CAN bus
On CAN bus error
LAST
Red
Blinking CAN bus warning / connected wrong
Green On Output on
O1 .. O5
Blank Off Output off