Nedap VP1007-B - Technical Specifications

VP1007-B / Installation manual
Version 01.000 / November 2020 / EN
21
Livestock Management
8 Technical specifications
VP1007-B
Item Specification
Dimensions (L x W x H) 143 x 120 x 68 mm (5.63 x 4.72 x 2.68 in.) (excluding mounting rail)
Weight Approx. 360 g (12.7 oz.)
Power supply The power supply or power adapter must comply with local regulations for a
SELV, limited power (NEC class2, ps2) output (e.g. Nedap VP2001 or Nedap
power adapter part no. 9223126).
Power supply input voltage 25 VDC, ± 20%
Power consumption, minimum 300 mA with the antenna switched on
Power consumption, maximum 4.5 A
Inputs Reading inputs, five analog (0-35V) and two digital
Suitable for NPN and PNP sensors
Outputs Max. 2A short-circuiting protected and over temperature protected, I/O
safeguard when total I/O current > 4A
Communication CAN bus 125 kbit/s
Serial interface RS-232, RS-485 (to connect other sensors with serial interfaces)
Cable specifications 
Power
1.5 mm
2
(0.0023 in.
2
) < 90 m (98 yd)
2 mm
2
(0.0031 in.
2
) < 100 m (109 yd)
CAN bus
Velos cable, min. 0.34 mm
2
(0.0005 in.
2
) twisted pair shielded < 90 m (98 yd)
Antenna Coax RG58. Max. length depending on antenna type.
Outputs CE approved at cable length < 3 m (10 ft)
Inputs CE approved at cable length < 3 m (10 ft)
Other 
Antennas Nedap antenna: Single Loop Walk Through, Single Loop Walk Over, VP6011,
VP6012, VP6030, VP6040, VP6041, VP6042 and VP6050.
Detection distance Varies per antenna
Synchronization According to ISO 11785
Software Downloadable by CAN network
Operating temperature range -10 to 50 °C (14 to 122 °F)
Storage temperature range -20 to 70 °C (-4 to 158 °F)
Operational relative humidity < 93% @ -20 to 70 °C (-4 to 158 °F)
Enclosure protection class IP30. When installed in V-box IP65 (cover and cables installed correctly!)
Maximum allowed environmental
noise level
10 dBµA/m quasi peak, according to CISPR 16-1-1
Maximum allowed conducted noise According to EN55032: 2015
Certifications CE, EAC, FCC, IC and KCC