EasyManua.ls Logo

Nemaxx BT55 - Safety Information

Nemaxx BT55
47 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
Version: 3.0
19.07.2017
KEN001BT55
EN
SAFETY INFORMATIONS
Carefully read the instruction manual and pay attention to the following safety
instructions.
Keep the instruction manual for future reference.
Check whether the mains voltage matches the one on the label of the device.
Don´t pull the mains plug in order to unplug the device from the socket.
Make sure not to damage or run over cables when moving the device.
The socket has to be earthed and appropriately secured.
The dehumidier must not be covered when used.
Don´t put clothes or other objects on it.
Only use the dehumidier on sturdy and even ground.
Repairs must be carried out by qualied experts with appropriate knowledge about the
product.
Don´t use adapters, additional connections or connecting plugs to connect the device
with an electricity supply.
Don´t put the device close to sources of heat, like radiators, radiant heaters, etc.
Don´t expose the product to direct sunlight or bad weather, like wind, storms and rain.
Unplug the device if problems like smell of burning occur while using it.
Don´t use the product close to chemicals and acids.
Those might damage the collection container or even the whole device.
Unplug the device if it is not used for a longer period or you want to clean it.
If you want to use permanent drainage, make sure that the hose is not bended and the
water can fl ow through unhindered.
Don´t use permanent drainage when tempe-ratures are very low and the water could
freeze.
Protect the device from splashing water.
Only use an earthed standard socket with a 220-240V AC connection.
Make sure that neither dryer, nor mains plug, nor socket is dusty.
This appliance is intended to be used by expert or trained users in shops, in light industry
and on farms, or for commercial use by lay persons.
The A-weighted emission sound pressure level at workstations does not exceed 70dB;
the peak C-weighted instantaneous sound pressure value at workstations does not
exceed 63Pa.
The product should be used on the back from the wall a distance of at least 50 cm,
the side away from the wall at least 30 cm.

Table of Contents

Related product manuals