Nemaxx BT55 - Error Messages; Error Analysis

8
Version: 3.0
19.07.2017 KEN001BT55
EN
ERROR MESSAGES
*Error Reason Solution
E1 Coil Sensor-Error Exchange the coil sensor.
E2 Moisture Sensor-Error Exchange the moisture sensor.
E3 Temperature Sensor-Error Exchange the temperature sensor.
E4 Hot and Cold System-Error
Have the dehumidier checked /
repaired by a specialist.
E5 Room Temperature too high
Lower the room temperature and
dehumidier will restart
automatically.
* If an error occurs, display will show the respective code.
ERROR ANALYSIS
Error Reason Solution
Dehumidier does
not work.
1. Device has no power.
2. Mains plug is not plugged in
properly.
3. Display shows error code E4.
1. Turn on the power supply.
2. Connect the mains plug properly.
3. Empty the water collection
container.
Bad dehumidication
performance
1. Air in- or outlet is covered.
2. Room is not closed.
Low moisture and temperature.
1. Uncover Air in- and outlet.
2. Close all doors and windows.
3. The lower the room temperature
the worse the dehumidi cation
performance.
High noise level
1. Device was not put on even
ground.
2. Air in- or outlet is covered.
1. Position the device on even
ground.
2. Uncover Air in- and outlet.