Need help?Do you have a question about the Nemtek Taut Wire Node and is the answer not in the manual?
General| Category | Control Unit |
|---|---|
| Operating Voltage | 12-24V DC |
| Wire Tension | Adjustable |
| Ingress Protection | IP65 |
| Housing Material | Polycarbonate |
| Current Consumption | 150mA |
| Detection Zones | Up to 8 zones |
| Communication | RS-485 |
| Description | The Druid Taut Wire Node is designed to detect cutting, climbing or lifting of taut wire perimeter security fences. Up to 8 Nodes can be connected to a single energizer. |
Details specifications for the Node board, including power, ratings, and temperature.
Specifies requirements for the recommended power supply and battery backup.
Outlines the procedures and options for installing the power supply for the Node board.
Illustrates the physical layout and labeling of components on the Node board.
Provides visual examples of how to connect Taut Wire sensors and other devices.
Explains how to configure jumpers for relay output (dry/wet) settings.
Describes the initial power-on sequence and display of the Taut Wire Node.
Explains how to navigate and view system status, alarms, and logs through the user interface.
Details configuration options and procedures for installers, including sensor addressing and saving settings.
To Next Page