Nemtek Taut Wire Node - Default Chapter; Table of Contents; History Channel

1 Introduction 3
2 Disclaimer 3
3 NEMTEK Group Outlets 4
4 Hardware Setup 5
4.1 Technical Specifications - Node Board 5
4.2 Technical Specifications - Recommended Power Supply with Battery 5
4.3 Power Supply Installation 6
4.4 Node Board Layout 7
4.5 Connection Examples 8
4.5.1 Taut Wire Sensors 8
4.5.2 Digital Outputs 8
4.5.3 Digital Inputs 9
4.5.4 Relay Outputs 10
4.6 Jumper Configuration 11
5 Software Setup 12
5.1 Startup 12
5.2 User Menus 12
5.2.1 Default Menu 12
5.2.2 Tautwire Channel 1 State 12
5.2.3 Tautwire Channel 2 State 12
5.2.4 History Channel 1 12
5.2.5 History Channel 2 12
5.2.6 Event Log 13
5.2.7 System Restart 13
5.3 Installer Menus 13
5.3.1 Channel 1 Installer Menu 13
5.3.2 Channel 2 Installer Menu 16
5.3.3 Log Repeat Interval 16
5.3.4 Set TW Node Address 16
5.3.5 Save Configuration 16
5.3.6 System Restart 16
Appendix A: Error/Alarm Codes 17
Installer Notes 18
Table of Contents
2