Neon MCB1533 - Sound Quality Adjustments; Volume and Bass Enhancement; Loudness and Equalizer Settings

GB-15
• Ifapowerfailureoccursortheunitisdisconnectedfromthemains,theclocksettingwillbe
lost.
Setting the Clock Automatically
Tune into a RDS station, press and hold the DISPLAY button. The clock will automatically
update.
Display the Clock
In any source mode, the built-in clock shows the time on the display by press the CLOCK
button.
Sound Quality
Adjusting the Volume
To increase or decrease the volume, rotate the - VOLUME + knob on the unit or press the VOL
+/- buttons on the remote control.
Adjusting the Super Bass
You can reinforce the bass sound to maintain rich, full bass at low volume.
Press the S-BASS button on the remote control to get the effect, the “ ” will lit on the front
panel. Press the S-BASS button again to cancel the effect.
Controlling the Loudness
This unit has a loudness function, which can automatically increase the bass sound effect at
low volume. It can also increase the bass sound effect at high volume, but it will be relatively
less when it is at high volume. Press the LOUDNESS button to obtain the loudness function,
the “
” will display on the front panel, press again will disappear.
Presetting Equalizer
You can adjust the sound reproduced simply by choosing from 5 preset equalizers.
During play, press the P-EQ button on the remote control repeatedly to select:
• [FLAT](FLAT)
• [POP](pop)
• [JAZZ](jazz)
• [ROCK](rock)
• [CLASSIC](classic)
Changing the Front Panel Darkness
This unit has three brightness levels for you to adjust the clock display. Press the DIM button
on the front panel or the remote control repeatedly to choose the desired brightness.