Neon MCB1533 - Radio Broadcasts Operation; Tuning and Station Selection; Preset Station Programming

GB-16
Listening to Radio Broadcasts
Caution: Before listening to the radio, please check that the FM Antenna is correctly connected
and adjusted for length and direction.
Tuning in to a Station
1. Repeatedly press the FUNCTION button on the unit or directly press the button on the
remote control to select tuner source.
- The word “TUNER” will be displayed on the front panel.
2. Select a station using one of the following methods.

Auto Tuning
Press and hold the
L
/
BF
button on the unit or
D
/
C
button on the remote control
for one second or more, the frequency changes down or up automatically until a station is
found.

Manual Tuning
Repeatedly press the
L
/
BF
button on the unit or
D
/
C
button on the remote control
tochangethefrequencyuntilyoundthestationyouwant.

Preset Tuning (Available only after the stations are preset)
Repeatedly press the
H
/
G
button to select the desired preset number. Its band and fre-
quency are displayed on the front panel.
Program radio stations
You can program a maximum of 20 preset radio stations (FM).

Automatically
Press and hold the PROG button on the remote control for two second or more to activate
automatic program mode.
- [AUTO]isdisplayed.
- All available stations are programmed.
- Therstprogrammedradiostationisbroadcastautomatically.

Manually
1. Tune to a radio station.
2. Press the PROG button on the remote control to activate program mode.
- The preset number will blink.
3. Press the
H
/
G
button to allocate a number to this radio station.
Note: If you select more than 20, the preset number will be changed to “1” automatically.
4. Press the PROG button on the remote control again to store the station.
5. Repeat above steps 1 to 4 for each station you want to store in memory with a preset
number.
Note: If the system is unplugged or if a power failure occurs, the preset stations will not be
erased.
To change the FM Reception Mode
Press the MODE button on the remote control to select the Stereo or Mono channel to receive
the best FM reception mode.