- 11 -
Switching ON / OFF
When you rst connect the unit to the AC power, the unit will be in clock mode.
- Press the
button to switch the unit on. The word “HELLO” will display on the display lens.
A countdown of 10 seconds starts for preheating of the system. Then, the system will switch
to the last selected source.
- Press the
button to switch the unit back to clock mode. The words “GOOD BYE” will
display on the display lens.
Reset Feature
Long pressing the
BF
button for 3 seconds or more to display the software version of the unit,
then press the
P-EQ
button to resets all the settings to factory default, “RESET” will display on
the display lens.
Note: This feature is only available for standby mode.
Setting the Clock
Caution: You can set the clock in clock mode only.
1. In clock mode, long pressing the
CLOCK
button on the remote control for more than 2
seconds to activate the clock setting mode, the time format [24--H] or [12--H] will blink.
2. Press the / buttons on the remote control to select a time format.
3. Press the
CLOCK
button to store the setting, the hour digits blink.
4. Repeat
above
steps 2-3 to set the hour and minute.
Note:
- To exit clock setting mode without storing, press the
L
button.
- If no button is pressed in 10 seconds, the unit exits clock setting mode automatically.
- If a power failure occurs or the unit is disconnected from the mains, the clock setting will be
lost.
To Next Page
Loading...