- 13 -
FM Radio Operation
Caution: Before listening to the radio, please check that the telescopic antenna on the rear of
the unit is correctly adjusted for length and direction.
Tuning in to a Station
1.
Repeatedly press the
SOURCE
button to select TUNER source. The word “TUNER” will display
on the display lens.
2. Select a station using one of the following methods.
Auto Tuning
Long pressing the
/ buttons on the remote control for more than 2 seconds, the frequen-
cy changes down or up automatically until a station is found.
Manual Tuning
Repeatedly press the
/ buttons on the remote control to change the frequency until you
nd the station you want.
Preset Tuning (Available only after the stations are preset)
Repeatedly press the
/ buttons on the remote control to select the desired preset num-
ber. Its band and frequency are
display on the display lens
.
Program radio stations
You can program a maximum of 20 preset radio stations (FM).
Automatically
Long pressing the
PROG
button on the remote control for more than 2 seconds to activate
automatic program mode.
- “AUTO” is
showed on the display lens
.
- All available stations are programmed.
- The rst programmed radio station is broadcast automatically.
Manually
1. Tune to a radio station.
2. Press the
PROG
button on the remote control to activate program mode. The preset number
and frequency will blink
on the display lens
.
3. Repeatedly press the
/ buttons on the remote control to select a number from 1–20 for
this radio station.
4. Press the
PROG
button on the remote control again to store the station.
5. Repeat above steps 1 to 4 for each station you want to store in memory with a preset number.
Note:If the system is unplugged or if a power failure occurs, the preset stations will not be losted.
To change the FM Reception Mode
Press the
REPEAT
button on the remote control to select the STEREO or MONO channel to
receive the best FM reception mode.
To Next Page
Loading...