Page 9
4. Assemble the DC power cord with the DC
power connector (included) for the PoE
injector.
5. Connect the DC power cable to the DC input
connector and tighten.
6. Run the Ethernet cable through the
watertight connector before terminating it.
7. Terminate the Ethernet cable.
8. Plug the Ethernet cable into the PoE
injector’s DATA PWR OUT port.
9. Secure all cables with zip ties.
10. Assemble the Ethernet connector at the
gateway unit, connecting the Ethernet cable
to the Ethernet/PoE input port on the
gateway.
To Next Page
Loading...
