netAlly LINKRUNNER G2 - Page 39

pop-up keyboard and enter the requested
wattage.
Enable TruePower™: Slide the toggle switch right
to enable the TruePower feature. TruePower val-
idates that the Switch (PSE) and cabling can
provide the requested power under load.
Connect
Speed/Duplex: Select the speed and duplex
option that you want to test your network against.
The default is Auto negotiation.
Security
802.1X Authentication: Slide the toggle switch
right to enable 802.1X authentication.
EAP Type: This field appears if 802.1X authen-
tication is enabled. Touch the down arrow to
choose the correct type. Additional security fields,
such as Username and Password, display as
required.
IP
IPv6: Slide the toggle switch right to enable IPv6.
39
LinkRunner G2 Application Settings