Link-Live: Slide the toggle to the left to disable
uploading of AutoTest results to Link-Live and
remove the Link-Live Upload card from the
AutoTest screen.
VLAN
Enable VLAN: Slide the toggle to the right to
enable VLAN settings. Once enabled, VLAN ID and
VLAN Priority fields appear. Touch these fields to
open a pop-up number pad and enter the correct
ID and priority. Touch OK to save them.
NOTE: When VLAN is enabled, the VLAN Test card
appears on the AutoTest screen.
User Defined MAC
Enable User Defined MAC: Slide the toggle to the
right to enable a user-defined MAC address. When
enabled, the User Defined MAC field turns from
grey to black.
User Defined MAC: If enabled, touch this field to
open a pop-up keyboard and enter your MAC
address. Touch OK to save it.
42
LinkRunner G2 Application Settings
To Next Page
Loading...
