2. When prompted, either enter the name of the image or accept the default image displayed inside the
brackets on your screen.
3. Restore the var file system:
If your system has… Then…
A network connection a.
On the impaired controller, press Y when you see
Do you want
to restore the backup configuration now?
b. On the impaired controller, press Y when prompted to overwrite
/etc/ssh/ssh_host_ecdsa_key.
c. On the healthy partner controller, set the impaired controller to
advanced privilege level: set -privilege advanced.
d. On the healthy partner controller, run the restore backup
command: system node restore-backup -node local -target
-address impaired_node_IP_address.
If you see any message other than a successful
restore, contact
NetApp Support.
e. On the healthy partner controller, return the impaired controller to
admin level: set -privilege admin.
f.
On the impaired controller, press y when you see
Was the
restore backup procedure successful?
.
g.
On the impaired controller, press y when you see
…would you
like to use this restored copy now?
.
h. On the impaired controller, press y when prompted to reboot the
impaired controller and press ctrl-c for the Boot Menu.
i. If the system does not use encyption, select Option 1 Normal
Boot., otherwise go to
Restore key managers.
j. Connect the console cable to the partner controller.
k. Give back the controller using the storage failover giveback
-fromnode local command.
1. Restore automatic giveback if you disabled it by using the
storage failover modify -node local -auto-giveback true
command.
l. If AutoSupport is enabled, restore/unsuppress automatic case
creation by using the system node autosupport invoke -node *
-type all -message MAINT=END command.
No network connection Contact NetApp Support.
No network connection and is in a
MetroCluster IP configuration
Contact NetApp Support.
10
To Next Page
Loading...
