EasyManua.ls Logo

NetApp AFF A70 - Page 11

NetApp AFF A70
107 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
a. Download the service image from the Downloads link on the page, to your work space on your laptop.
b. Unzip the service image.
If you are extracting the contents using Windows, do not use WinZip to extract the
netboot image. Use another extraction tool, such as 7-Zip or WinRAR.
The USB flash drive should have the appropriate ONTAP image of what the impaired controller is running.
a. Remove the USB flash drive from your laptop.
2. Insert the USB flash drive into the USB slot on the System Management module.
Make sure that you install the USB flash drive in the slot labeled for USB devices, and not in the USB
console port.
3. Plug the power cables into the power supplies and reinstall the power cable retainer.
The controller begins to boot as soon as power is reconnected to the system.
4. Interrupt the boot process by pressing Ctrl-C to stop at the LOADER prompt.
If you miss this message, press Ctrl-C, select the option to boot to Maintenance mode, and then halt the
controller to boot to LOADER.
5. Set your network connection type at the LOADER prompt:
If you are configuring DHCP:
ifconfig e0M -auto
The target port you configure is the target port you use to communicate with the
impaired controller from the healthy controller during var file system restore with a
network connection. You can also use the e0M port in this command.
If you are configuring manual connections:
ifconfig e0M -addr=filer_addr -mask=netmask
-gw=gateway
filer_addr is the IP address of the storage system.
netmask is the network mask of the management network that is connected to the HA partner.
gateway is the gateway for the network.
Other parameters might be necessary for your interface. You can enter help ifconfig at the
firmware prompt for details.
Boot the recovery image - AFF A70, AFF A90
You must boot the ONTAP image from the USB drive, restore the file system, and verify
the environmental variables.
Steps
1. From the LOADER prompt, boot the recovery image from the USB flash drive: boot_recovery
The image is downloaded from the USB flash drive.
9

Related product manuals