The controller module boots when power is restored. If it boots to the LOADER prompt, reboot the
controller with the
boot_ontap command.
6.
Restore automatic giveback if you disabled it by using the
storage failover modify -node local
-auto-giveback true
command.
7.
If AutoSupport is enabled, restore/unsuppress automatic case creation by using the
system node
autosupport invoke -node * -type all -message MAINT=END
command.
8. If you have not already done so, reinstall the cable management device and recable the controller.
Restore and verify the system configuration - AFF A70, AFF A90
After completing the hardware replacement, you verify the low-level system configuration
of the replacement controller and reconfigure system settings as necessary.
Step 1: Set and verify system time
You should check the time and date on the replacement controller module against the healthy controller
module in an HA pair, or against a reliable time server in a stand-alone configuration. If the time and date do
not match, you must reset them on the replacement controller module to prevent possible outages on clients
due to time differences.
About this task
It is important that you apply the commands in the steps on the correct systems:
• The replacement node is the new node that replaced the impaired node as part of this procedure.
• The healthy node is the HA partner of the replacement node.
Steps
1. If the replacement node is not at the LOADER prompt, halt the system to the LOADER prompt.
2.
On the healthy node, check the system time:
cluster date show
The date and time are based on the configured timezone.
3.
At the LOADER prompt, check the date and time on the replacement node:
show date
The date and time are given in GMT.
4.
If necessary, set the date in GMT on the replacement node:
set date mm/dd/yyyy
5.
If necessary, set the time in GMT on the replacement node:
set time hh:mm:ss
6.
At the LOADER prompt, confirm the date and time on the replacement node:
show date
The date and time are given in GMT.
Step 2: Verify and set the HA state of the chassis
You must verify the
HA state of the controller module and, if necessary, update the state to match your system
configuration.
1.
In Maintenance mode from the new controller module, verify that all components display the same
HA
39
To Next Page
Loading...
