state: ha-config show
The HA state should be the same for all components.
2.
If the displayed system state of the controller module does not match your system configuration, set the
HA
state for the controller module: ha-config modify controller ha-state
The value for HA-state can be one of the following:
◦
ha
◦
mcc (not supported)
◦
mccip
◦
non-ha (not supported)
3.
If the displayed system state of the controller module does not match your system configuration, set the
HA
state for the controller module: ha-config modify controller ha-state
4.
Confirm that the setting has changed:
ha-config show
Recable and give back the controller - AFF A70, AFF A90
Continue the replacement procedure by recabling the storage, network connections and
giving back the controller.
Step 1: Recable the system
Recable the controller module’s storage and network connections.
Steps
1. Recable the the controller module to storage and network conntections.
2. Verify that the cabling is correct by using
Active IQ Config Advisor.
a. Download and install Config Advisor.
b. Enter the information for the target system, and then click Collect Data.
c. Click the Cabling tab, and then examine the output. Make sure that all disk shelves are displayed and
all disks appear in the output, correcting any cabling issues you find.
d. Check other cabling by clicking the appropriate tab, and then examining the output from Config Advisor.
Step 2: Give back the controller
1. If your storage system has Encryption configured, you must restore Storage or Volume Encryption
functionality using the following procedure to reboot the system:
a. Boot to Menu and run Option 10
b. Input the passphrase & backup up data, then do Normal boot see
Restore onboard key management
encryption keys
.
c. Perform CFO only giveback
d. Perform Onboard Sync and verify SVM-KEK is set to true see
Giveback after MB replacement fails -
operation was vetoed by keymanager
40
To Next Page
Loading...
