Need help?Do you have a question about the NetApp DS4246 and is the answer not in the manual?
General| Data transfer rate | 6 Gbit/s |
|---|---|
| Storage drive size | 3.5 \ |
| Storage drive interface | Serial Attached SCSI (SAS) |
| Storage drives installed | Yes |
| Installed storage drive type | HDD |
| Supported storage drive types | HDD & SSD |
| Total installed storage capacity | 40.8 TB |
| Maximum supported storage capacity | - TB |
| Number of storage drives installed | 24 |
| Chassis type | Rack (4U) |
| Product color | Black |
| Device class | Large Enterprise Business |
| AC input voltage | 100-240 V |
| AC input frequency | 50 - 60 Hz |
| Number of power supply units | 2 |
| Operating altitude | 0 - 3045 m |
| Non-operating altitude | -305 - 12192 m |
| Storage temperature (T-T) | -40 - 70 °C |
| Operating temperature (T-T) | 10 - 40 °C |
| Storage relative humidity (H-H) | 10 - 95 % |
| Operating relative humidity (H-H) | 20 - 80 % |
Weight and Dimensions| Depth | 610 mm |
|---|---|
| Width | 483 mm |
| Height | 178 mm |
Guidelines for safe physical installation of disk shelves in racks and cabinets.
Safety precautions for electrical connections and power management of disk shelves.
Safety procedures for handling and managing disk shelf components.
Step-by-step guide for modifying the disk shelf ID.
Requirements and system checks before hot-adding SAS disk shelves.
Physical installation steps for a disk shelf during a hot-add.
Procedure to remove disk shelves when system halt is required.
Monitoring disk drive and carrier status via LEDs and console messages.
Monitoring power supply status using LEDs and console messages.
Procedures for replacing SAS cables in various system configurations.
Detailed procedure for replacing an entire disk shelf.
To Next Page
